CNC_RDTOOLGRP | TOOLLIFE

Description

Declaration

Arguments

typedef struct odbtg {
    short  grp_num ;   /* Tool group number. */
    short  dummy[2] ;  /* Not used. */
    long  ntool ;      /* Number of tool. */
    long  life ;       /* Tool life value. */
    long  count ;      /* Tool life counter. */
    struct {
        long  tuse_num ;   /* Tool use-order number */
        long  tool_num ;   /* Tool number */
        long  length_num ; /* Tool length compensation no.*/
        long  radius_num ;/* Cutter radius compensation no.*/
        long  tinfo ;      /* Tool information. */
    } data[N] ;
} ODBTG ;                    /* N is Number of tool. */

Return

EW_OK is returned on successful completion, otherwise any value except EW_OK is returned.

The major error codes are as follows.

As for the other return codes or the details, see "Return status of Data window function"

CNC option

This function need the following CNC option.

The tool life management function is necessary.

And this function is related to the following CNC option.

• Series 15/15i
  

  This function is influenced by 1024/512 pairs of the tool life management.

• Series 16/18/21, 16i/18i/21i
  

  This function is influenced by 512(M Series)/128(T Series) pairs of the tool life management.

• Series 0i-F, 30i
  

  This function is influenced by additional pairs number of the tool life management.

  the tool life management	:	256 pairs of the tool life management on whole system, both of M and T Series
  additional pairs number of the tool life management	:	1024 pairs of the tool life management on whole system, both of M and T Series

For HSSB connection,

The extended driver/library function is necessary.

For Ethernet connection,

The Ethernet function and the extended driver/library function are necessary.

However, in case of Series 16i/18i/21i-B, 0i-B/C/D/F and 30i the required CNC option is as follows.

When Embedded Ethernet is used,

above two optional functions are not required.

When Ethernet board is used,

only Ethernet function is required.

CNC parameter

This function is related to the following CNC parameter.
See the manual of CNC parameter for details.

• Series 15/15i
7400#0,#1,#3
• Series 16/18/21, 16i/18i/21i
6800#0,#1,#2
• Series 30i
6800#0,#1,#2
6813

• Series 0i-A/B/C
6800#0,#1,#2
8132#0=1 (must be set)
• Series 0i-D/F
6800#0,#1,#2
6813
8132#0=1 (must be set)

CNC mode

This function can be used in any CNC mode.

Available CNC

Note) 0i-C does not support the HSSB function.